In this post, we’ll intriduce three ways to reset Antminer L3+ to factory settings, read the content of this article first.
There are three ways to restore factory settings:
Table of Contents
1. Restore Via the “Reset” Button
10 minutes after the miner has started, this technique can be used.
After the miner is turned on for 2 minutes, please press and hold the “Reset” button for 5 seconds, and then release it. Without needing to be shut down, the miner will automatically restart and return to its factory settings after 4 minutes.
2. Recover Via Software
Log in to your miner interface, click Upgrade> Perform Reset, and click “OK” in the pop-up window.
3. Recover Via the “IP Report” Button
Reminder: The miner will automatically revert to factory default firmware.
Only miners with an SD card slot on the left side of the Ethernet interface can use this method.
Please halt the miner before pressing and holding the IP Reporter without letting go. Open the miner once more simultaneously. After 5 seconds, release IP Reporter, and the miner will automatically return to its default settings.
SD cards on the right side of the Ethernet interface are not compatible with miners using this technique.
The miner will revert to its original firmware after being reset. Update the L3 miner’s firmware by reloading it.
